SwedeSpeed - Volvo Performance Forum banner
1 - 1 of 1 Posts

4 Posts
Discussion Starter · #1 ·
Hi guys,

Has anyone done any reverse engineering on the Vehicle cable part of the VCT2000 setup. This is the cable that goes from the VCT2000 box to the OBD socket on the car.

Is this just a standard cable? The old ones had a blue box partway along the cable as if it contained more electronics, but some of the later ones dont seem to have this and just look like a straight cable.

These cables are quite pricey from volvo. Was wondering if anyone had successfully made one to replace the volvo cable, or know whats in them.... opto isolators, voltage regulators etc.... That type of thing?

Anyone know the pinout from the VCT2000 box on the can bus side, not the RS232.

Cheers guys.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.