Are you looking for the installation guide in VADIS, or just the schematics of the MAP sensor?

 

Here is the parts catalog diagram in VADIS. Although, there is not information for the number 10 associated with the MAP sensor. Let me know if this is what you're looking for. I also don't see any information in the repair section of VADIS.

 

Re: VADIS - replacing MAP sensor (Bender)

The MAP is just stuffed on top of the charge pipe, mid-way from the I/C to the throttle. Pull the plug, pull the sensor out (it has a securing screw), push new one in.

 

thanks

 

Here is a better picture of the MAP sensor located on the inlet pipe. I guess because the pipe wasn't included in the manifold diagram they didn't provide any information on it. Here is a picture of it where it is actually located in the engine.

 

Re: (cmurphy2266)

Curious - how would you know when to replace this?

 

Re: (Turbos60)

Some common characteristics of a failing MAP sensor would be as simple as a CEL, or hesitation in acceleration, or even poor engine performance.

 

Re: (cmurphy2266)

Quote, originally posted by cmurphy2266 »

Here is a better picture of the MAP sensor located on the inlet pipe. I guess because the pipe wasn't included in the manifold diagram they didn't provide any information on it. Here is a picture of it where it is actually located in the engine.

bingo - exactly what i thought. http://********************/smile/emthup.gif

 

my symptoms:
Above 2k - gradual acceleration - no issues.
Below 2k - gradual acceleratoin - no issues

Above 2k- Moderate to Aggressive acceleration - slight stumbling down low - smooths out the farther from 2k you are
Below 2k - Moderate to Aggressive acceleration - SEVERE stumbling

If i start from clean no CELS the first two times i run the car I get ZERO CELs. On the third time i start the car (after the two previous drives) i get CELs 235 and 236 which are circuit malfunctions relating to boost

Reflashed my ECU (not to stock, but re-tuned it with soft loader)
Same issue
Reflashed to stock
Same issue

TCV is brand new and functioning correctly - i think it has to be the MAP

 

Is this what you're experiencing?

http://forums.swedespeed.com/zerothread?id=118952

 

similar but not quiet - joes seems much more severe and i am getting codes (p0235 and p0236)

 

MAP replaced - codes not repeating - smooth as silk!