SwedeSpeed - Volvo Performance Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
Hi I’ve just joined and hope this is in the right place.
im looking for advice with my sons 08 v50 d5 it’s showing no fault codes, and it goes as if it’s in limp mode no power whatsoever I’ve cleaned the throttle body and the egr I’ve looked for any pipes off and tried to find any vacuum leaks , the swirl flaps have been disconnected by the previous owner , I’ve had my friend put his autel on but has found nothing I think it’s a euro 5 engine, any help advice would be gratefully received.
thanks
 

·
Registered
Joined
·
4 Posts
Discussion Starter · #3 ·
Thank you RR04 only now seen your reply I think the swirl flaps have been programmed out there’s also a spring on them pulling them open I have since put a dice on the car and shows codes 9140 and 9180 Tcm faulty signal put a known working tcm on it and is still the same also changed the boost valve only thing I can think of now is to check the wires from ecm to Tcm so now looking for a pin out for the ecm if you can help thx
 
1 - 2 of 2 Posts
Top