SwedeSpeed - Volvo Performance Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
217 Posts
Discussion Starter · #1 ·
hi all,
i received my tire pressure monitoring system from ipdusa today. i tried to install it, but i have one problem with the wiring.
there are three wires that i need to connect.
one is black, ground wire, i know where that goes.
one is red, +12V dc, i am not too sure where it goes, but i may be able to figure it out.
one is orange, ACC wire. this i have no clue where it goes. what is the ACC wire? on the wiring diagram it says it connects to the ignition. im lost...
any help would be great. and anyone who actaully installed one of these please help me out.
thanks in advance for any help.
 

·
Registered
Joined
·
411 Posts
Re: tire pressure monitoring system help needed (biotek)

ACC is the accessory position of the ignition.

0 - Locked position
Remove the key to lock the steering wheel1. Never turn the key to position 0 while driving or when the vehicle is being towed.
NOTE: A ticking sound may be audible if the key is turned to a position between 0 and I. To stop this sound, turn the key to position II and back to position 0.

I - Intermediate position
Certain accessories, radio, etc. on, daytime running lights off

1. The gear selector must be in the Park position.
2. Please be aware that leaving the key in this position will increase battery drain.

Modified by cmy4x4 at 5:46 PM 5-3-2006

Modified by cmy4x4 at 5:46 PM 5-3-2006
 
1 - 2 of 2 Posts
Top