SwedeSpeed - Volvo Performance Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
273 Posts
Discussion Starter · #1 ·
I want to make a light bar for my SX4. If i show up to a muffler shop with a template and a length of T-304 tube and ask them to bend it for me, will they think i am a jackass? I figure money is money where else can i get tubing bent?<p> <IMG NAME="icon" SRC="http://www.vwvortex.com/zeroforum_graphics/screwy.gif" BORDER="0"> <IMG NAME="icon" SRC="http://www.vwvortex.com/zeroforum_graphics/screwy.gif" BORDER="0"> <IMG NAME="icon" SRC="http://www.vwvortex.com/zeroforum_graphics/screwy.gif" BORDER="0"> <IMG NAME="icon" SRC="http://www.vwvortex.com/zeroforum_graphics/screwy.gif" BORDER="0"> <IMG NAME="icon" SRC="http://www.vwvortex.com/zeroforum_graphics/screwy.gif" BORDER="0"> <IMG NAME="icon" SRC="http://www.vwvortex.com/zeroforum_graphics/screwy.gif" BORDER="0">
 

·
Registered
Joined
·
483 Posts
Re: Sorry, non R related fabrication question (j0sie27)

If you go to an A$$ Hole than they might.. but.. my guy bends me stuff all the time for my retarded projects.
 

·
Registered
Joined
·
1,309 Posts
Most local ma and pop places would happily bend it for you.<br>Tuffy or Menike though may not, especially on a busy day. You never know though...I've had my local Tuffy do stuff for me for a few bucks when they were slow and about to close.
 
1 - 3 of 3 Posts
Top