So I have watched Lucky's videos over and over and over... I still can't figure out exactly the fine tips of setting the wastegate the proper way (with a pressure pump and gauge). Most everything I find online caters to wastegates where you can disconnect the rod from the wastegate lever. Following the method of a conventional setup, I'm assuming I can set my pressure to 4.4psi (for factory level of a B5254T4) or 6.4psi (for higher boost levels) and adjust the rod until it's in a neutral force position, ie not pulling or pushing between the wastegate lever and the diaphragm. This would be the same as adjusting the rod on a conventional arm, so the eye of the shaft lines up with the pin of the wastegate arm.
Anyone have proper experience with this? Have more tips?
Anyone have proper experience with this? Have more tips?
