SwedeSpeed - Volvo Performance Forum banner

1 - 20 of 304 Posts

·
Super Moderator
Joined
·
14,831 Posts
Discussion Starter · #1 · (Edited)
We finally got setup as banner advertiser, so we can discuss this openly. :D

I had intended to run the GB last month but because of the delay in getting setup and scheduling, it was best to wait until July to start the promo. I've made some changes and Phuzzy Motorsports will be running more on a full-time schedule with better availability and quicker response times., and it will allow for development of new products.

That being said, it is very hot out and I'm sure those of you with stock intercoolers can tell more than anyone. The new version of the PhMIC will be including the remainder of the cold-side piping which connects directly to the Throttle Body and no longer requires connecting to the last section of the OE plastic piping.

GB Rates as Follows (excl. shipping / installation):
1-4: 5%
5-9: 10%
10+: 15%

The new DP with cutout option is to be included with this as soon as we set the final price in the next few days.



1. PC Diesel
2. mcopare
3. Scuba Jim
4. coachvin
5. s_ager
6. vLGrok
7. zeedragon
8. MN-TURBOR
9. Billybo455
10. Mike W.
11. DevolvR
12. dmvee70r
 

·
Registered
Joined
·
1,341 Posts
interested in the PHMIC.
 

·
Registered
Joined
·
103 Posts
Intercooler please.
 

·
Registered
Joined
·
172 Posts
Intercooler +1
 

·
Registered
Joined
·
119 Posts
In
 

·
Registered
Joined
·
1,028 Posts
In for IC if we can get to 15%.
My sigline needs some phuzzy.
 

·
Registered
Joined
·
11,628 Posts
Nice pic, too bad the car in the pic is running a TME DP and Exhaust and oh ya that's my pic/car you have there :p
 

·
Registered
Joined
·
332 Posts

·
Registered
Joined
·
221 Posts

·
Super Moderator
Joined
·
14,831 Posts
Discussion Starter · #13 ·
you have a port for the wideband so we can custome tune our engines ???????
Yes, the third port can be easily added.

Curious, though, what software are you using to do your custom tuning?
 

·
Registered
Joined
·
1,292 Posts
I'd be down for a PhMIC at the 15% off rate!
 

·
Registered
Joined
·
1,028 Posts

·
Super Moderator
Joined
·
14,831 Posts
Discussion Starter · #17 ·
List updated....looks like we already have the 15%.
 

·
Registered
Joined
·
101 Posts
Hope it is ok to ask this question... I am really interested in the IC, but I don't even wanna try to install it myself. Can anyone recommend an installer in the area around MD?

And if you can... can you give me an estimate on how much it would cost?
 

·
Registered
Joined
·
1,028 Posts
List updated....looks like we already have the 15%.
Clean your private message box on forum! Mind if I call you this evening to place my order? Going to be slammed at work tomorrow. In fact, I'm still at work.
 

·
Super Moderator
Joined
·
14,831 Posts
Discussion Starter · #20 ·
We can do the installations at the facility, which is located in Lancaster, PA for those who want to make the drive.
Intercooler installations are $275 flat rate.
Downpipe installations are $125 flat rate.
 
1 - 20 of 304 Posts
Top