SwedeSpeed - Volvo Performance Forum banner
1 - 1 of 1 Posts

· Registered
10,051 Posts
Re: Is it possible to unbend a door? (KVB)

Quote, originally posted by KVB »

Go find a small chunk of 2x4 or 4x4 like 4-6" long. Place the wood in the door jam in a sturdy place, preferably the latch area. Make sure you roll down the glass before you get started. Then start pushing on the door at the corner that needs to move inword. Just give it a good shove or two and then pull the wood and check to see how it's lined up. Repeat until you get it right.


This procedure but performed by a pro so you can blame it all on them might things go wrong..
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.