SwedeSpeed - Volvo Performance Forum banner

Double din install pics

7K views 6 replies 4 participants last post by  sclarke7171 
#1 ·
nice and tight , not going anywhere.



how to remove from back with a plain screwdriver...simply push it out



from ACE HARDWARE sliders
these are foamy and to hold the sliders I use 3M double tape.



these are rubber type.

 
See less See more
4
#6 ·
Thanks...the trim is not trimmed but I did cut on top of the bezel trim 3 lill tabs in the middle by 2mm back cause it is from JVC radio.
 
#5 · (Edited)
Thank you. I can take more pics for you, but what details are you looking for? it just slides in just the way you see it no modification whatsoever...other than the bezel , it is from JVC double dim and it is glued on to radio as you see in the 2nd pic.... here is what I am working on now my XC90 and s60 that is done...oh sorry ,one thing that I made is a lill bracket in back of the dash/for radio so it does not slide in and it stays right where it's at.


 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top