SwedeSpeed - Volvo Performance Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
I think I read somewhere (maybe that OTHER Volvo forum site!!) that one can use an DC voltmeter (analog?)to read fault codes set by the ECM in 700 series models. Anybody able to cast some light on the subject as to how one goes about it ??<BR>Thanks
 

·
Registered
Joined
·
1 Posts
It's not that hard......you can read the codes on the OBDI systems right from the diagnostic system by the drivers side strut tower (Inside the engine compartment). Complete instructions can be found at <A HREF="http://www.swedishbricks.net/700900FAQ/Engine-Codes1.html#Engine" TARGET=_blank>http://www.swedishbricks.net/700900FAQ/Engine-Codes1.html#Engine</A> and OBD Diagnostic Codes
 
1 - 2 of 2 Posts
Top