SwedeSpeed - Volvo Performance Forum banner

1 - 10 of 10 Posts

·
Registered
Joined
·
11 Posts
Discussion Starter · #1 ·
I am clearing out some 240 parts that I have.<p>Some performance stuff like bilsteins, A-cam, gauge pod, and strut tower braces.<p>Also a variety of new-in-package parts from IPD/FCP (water pump, bushings).<br>(previously listed harmonic balancer and belts are gone).<p>Nice 2" trailer hitch, including the big bolts / nuts to fasten it to the car.<p>A bunch of used spares (relays, bulbs, bolts).<p>Email with needs.<br>Located in MN. Willing to ship (buyer pays shipping). Paypal ok.<p><BR><BR>
<i>Modified by maxbrix at 1:21 PM 9-3-2009</i>
 

·
Registered
Joined
·
3,126 Posts
Re: Clearing out 240 parts (maxbrix)

IM with questions sent.
 

·
Registered
Joined
·
1 Posts
Re: Clearing out 240 parts (maxbrix)

Hi,<br>I was in town all summer and too bad I didn't see your post. I'm back in southwest Virginia until later this fall.<p>I have a 91 240. 13 Minnesota winters did not treat it well. Rust on botton of doors . . .I just replaced all suspension bushings, torque rod bushings, tie rod ends, ball joints, brakes (rotors and pads but not the calipers) and added glass lights. In spite of the brake change, they still don't feel all that great. Maybe I should have done the calipers, too. <p>Not much power in engine (around 225,000). I need to replace belts, neutral safety switch (no reverse lights), those bushings in shifter without which you hear a real racket when you shift the AT, need bulb for shifter, too and probably soon for dashas well. <p>Probably will get oxygen sensor. I don't think it was ever replaced. Is the harmonic balancer something you need to change before it stops functioning?<p>I blew a lot of dough paying someone to do the bushing and brake job. All the rust meant that a torch was needed and I just couldn't do that work.<p>Anyway, sorry about the rambling post. Let me know if you have any of the above or any ideas or perhaps I could call to avoid a lot of time consuming emailing.<p>Thanks,<br>Warren
 

·
Registered
Joined
·
11 Posts
Discussion Starter · #6 ·
Re: Clearing out 240 parts (joerichproject)

TTT<br> <IMG NAME="icon" SRC="http://********************/smile/emcocktl.gif" BORDER="0"> <IMG NAME="icon" SRC="http://********************/smile/emcocktl.gif" BORDER="0">
 

·
Registered
Joined
·
11 Posts
Discussion Starter · #8 ·
Re: Clearing out 240 parts (maxbrix)

Still available.<br>TTT.<br> <IMG NAME="icon" SRC="http://www.vwvortex.com/vwbb/embeer.gif" BORDER="0">
 
1 - 10 of 10 Posts
Top