[R_Rated]

I have been thinking about ways to test different theories for modded airboxes/intakes/"Kelly" ram air. Since a dyno will be useless to measure the gaines here try this:

I always tape my front end for road trips and traveling to shows. Takes 5 minutes and keeps from getting peppered with rock chips and bugs. Blue painters tape comes off easy and leaves NO residue.

Take one strip and place it where the Evolve Hood vent would go leaving the end folded over to act as a "flap" for the wind/air to catch.

Then take a second piece (just a small square will work) and place it over the part of the grill where you would put the entrance to Kelly's air mod.

 

[R_Rated]

I also used a CFD (basically a virtual wind tunnel) software but not everyone has access to that, lol.

 

[R_Rated]

Re: (JimLill)

Quote, originally posted by JimLill »

see: http://www.microcfd.com/download.htm

that is a far cry from a "real" CFD tool...

http://www.ansys.com/products/icemcfd.asp

-or-

http://www.macroindustries.com/website/index.htm

 

[R_Rated]

BTW, the intent of this thread was to "prove" the DIY mod not todisprove anything else.