SwedeSpeed - Volvo Performance Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
684 Posts
Discussion Starter · #1 ·
I have a few rebuilt 19Ts ready to be shipped out. There were 15G but modified to be 19T. These 19Ts have the same specs as stock 19Ts. All my turbine housings are 7cm^2.

They come with 15G actuators, which is good for up to around 15-17psi. Garrett actuator upgrade is available, good for up to 25psi.

Pricing is as follow,

19T with no turbine housing nor actuator $580 + shipping.
19T with flat housing and 15G actuator $630 + shipping.
19T with flat housing and Garrett actuator $680 + shipping.
19T with angle housing and 15G actuator $680 + shipping.
19T with angle housing and Garrett actuator $730 + shipping

We can weld V-band onto the turbine housing for extra fee if desired!


I don't have any ECU tune available at the moment.

Please don't chatter up in this thread with unhelpful comments.
Please PM me if you have any question, thanks.









 

·
Registered
Joined
·
684 Posts
Discussion Starter · #3 ·
Re: 19T Turbos Drop-in upgrade (MyVolvoripurS4)

Hi,

I would not run this turbo with stock tune. You'll need a ECU that knows you're putting more air into the engine thus, add fuel as well.

I recommend a new oil feed line to go with the new turbo.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top